Quickly 4C/4D/46/48 Code Reader Chip Transponder V2.14.8.16 Plus 4D Decoder Clone Box

Special Notice

For 4D and 46 copy function, need buy special 4D and 46 decoder with dedicated chips.

Instruction for use

1. The external interface as show in following picture:

2. Identify the chip

Put the chip into the chip read area and click "chip reading and writing". If there is a chip, the corresponding chip and parameter will be displayed, as show in following picture:



3. Copy the chip

For examply: copy the chip 42. Firstly, put the key that can start the original car into the chip reader area to read data, as show in following picture.
Then decoder, remove the key of original car, put into the new chip 42, click "copy", as show in next picture---OK!

4. Additional settings

For example: in order to generate the chip 4D67, we first put a blank chip 4D60 into the chip reader area and then click "additional settings"--"key cutting",
as show in Fig.(6)---click 67, as show in Fig(7)---generate data---done, as show in Fig.(8)



5. Identify whether Toyota smart key has been used or not

For example: put Toyota smart key into the chip read area and click "additional settings"--- reading of "smart key", it will show you it is new or used.

6. Detect the frequency

Put the key of the remote controller into the frequency detection area in a flat manner, and click "frequency detection" in the menu;
then, press any key of the remote controller, and corresponding frequency, ID, modulation mode, speed and other parameters are then show on the screen.