ECU Programmer For TOYOTA

flash, is a multipurpose programmer for Denso and Fujitsu Ten ECUs with NEC processors installed For TOYOTA/LEXUS/SCION vehicles with petrol and diesel engines through JTAG interface

Best ECU Programmer For TOYOTA / LEXUS ECU FLASHER READ And WRITE ECU TCU via OBD For NEC 7F00XX series MCU Chip Tuning Tool is a one of our ECU Programmer For TOYOTA Tools, you can buy Best ECU Programmer For TOYOTA / LEXUS ECU FLASHER READ And WRITE ECU TCU via OBD For NEC 7F00XX series MCU Chip Tuning Tool from chinaobd2.com.

Wholesale Top quality BENZ ECOM DoIP Diagnostic and Programming Tool, Super DSP3+ Odometer Correction Tool, VAS 5054A ODIS GM Tech2, Scania VCI3

images of Best ECU Programmer For TOYOTA / LEXUS ECU FLASHER READ And WRITE ECU TCU via OBD For NEC 7F00XX series MCU Chip Tuning Tool

Best ECU Programmer For TOYOTA / LEXUS ECU FLASHER READ And WRITE ECU TCU via OBD For NEC 7F00XX series MCU Chip Tuning ToolBest ECU Programmer For TOYOTA / LEXUS ECU FLASHER READ And WRITE ECU TCU via OBD For NEC 7F00XX series MCU Chip Tuning ToolBest ECU Programmer For TOYOTA / LEXUS ECU FLASHER READ And WRITE ECU TCU via OBD For NEC 7F00XX series MCU Chip Tuning ToolBest ECU Programmer For TOYOTA / LEXUS ECU FLASHER READ And WRITE ECU TCU via OBD For NEC 7F00XX series MCU Chip Tuning ToolBest ECU Programmer For TOYOTA / LEXUS ECU FLASHER READ And WRITE ECU TCU via OBD For NEC 7F00XX series MCU Chip Tuning ToolBest ECU Programmer For TOYOTA / LEXUS ECU FLASHER READ And WRITE ECU TCU via OBD For NEC 7F00XX series MCU Chip Tuning Tool

Introduction:
For Toyota Flasher, a joint project by Autokey and P.C.M.flash, is a multipurpose programmer for Denso and Fujitsu Ten ECUs with NEC processors installed For TOYOTA/LEXUS/SCION vehicles with petrol and diesel engines through JTAG interface. OBD writing via CAN bus is supported. It is a unique solution in the chip tuning world. It covers almost all the models beginning from 2003-2004. It can read, flash, clear, verificate internal flash memory of microcontrollers if connected to the appropriate connector on the ECU circuit board.
Advantages:
·Its own hardware interface allows to avoid all compatibility and driver problems;
·Work through built-in 20 or 26 pin JTAG connector;
·Full access to the ECU memory at high speed of more than 100 KB/s;
·Saving files in the open format;
·Firmware checksum verification and recalculation.
·SUPPORT 2015 + OBD WRITE and SOME MODELS 2015 + OBD READ
·can READ and WRITE via internal 20 pin or 26 pin connector. connection diagram for all known
Supported ECUs:
For TOYOTA DENSO engine CONTROL MODULE based on NEC 7F00XX series MCU :
76F0038
7F0038A
76F0039
76F0039A
76F0040
76F0040A
76F0070 BGA
76F0085 BGA
saving in normal mode without any master-slave.
master only.
auto CHECKSUM CORRECTION support
These processors were introduced at the beginning of CAN support and as a rule with coachwork change.
Package List:
ECU Flash main unit
Cables
Best ECU Programmer Best ECU Programmer Best ECU Programmer Best ECU Programmer Best ECU Programmer

Go to Buy: Best ECU Programmer For TOYOTA / LEXUS ECU FLASHER READ And WRITE ECU TCU via OBD For NEC 7F00XX series MCU Chip Tuning Tool

Share to Pinterest