VIDENT iLink450 ABS &SRS reset /DPF/Battery Configuration Full Service Tool

VIDENT iLink 450 supports ABS&SRS reset /DPF/Battery Configuration Full Service Tool

VIDENT iLink 450 Features:

Service/Oil Light Reset coverage for over 40 Asian and European vehicle makes:

1.Resets Oil Service Light
2.Resets Oil Inspection Light
3.Sets Inspection Service Interval (1 & 2)
4.Sets Inspection Mileage
5.Provides on-screen service reset instructions for vehicles which do not support electronic service resets
6.Languages: English, Portuguese

Electronic Parking Brake(EPB) servicing coverage for over 30 Asian and European vehicle makes:

1.Deactivates and re-activates brake control system
2.Retracts calipers for brake pad replacement
3.Advances calipers after servicing to the original position, without affecting current calibration
4.Reads and clears trouble codes (fault codes)
5.Turns off brake warning light
6.Initializes the wear indicator if required when new pads installed
7.Diagnoses EPB/SBC caliper functionality
8.Resets the brake pad thickness after service on Audi A8
9.Performs ECU controlled brake fluid change

VIDENT iLink 450 Battery Configuration(BRT)

After changing battery on cars, particularly if equipped with Start & Stop function and/or regenerative breaking system, a smart battery replacement tool as iLink450 is required to associate the new battery with the vehicle ECU to complete the job and start the engine. iLink450 offers a cost-effective solution for independent garages to work on modern vehicle battery and helps them to get prepared for the future of the battery business. Supports all brands of battery.

VIDENT iLink 450 ABS & Airbag Reset

Reads and clear codes and turns off ABS/Airbag warning indicator. Performs bi-directional control tests, such as ABS motor test, actuator test, ABS bleeding, airbag reset and so on.

VIDENT iLink 450 Throttle Body Alignment (TBA/TPS)

After cleaning or replacing the Electronic Throttle Body, adaptation must be carried out (also the case if the negative terminal of the battery has been disconnected or when the engine Control Unit has been replaced). The iLink450 will perform Electronic Throttle Body adaptations on supported vehicles.

VIDENT iLink 450 SAS Reset Function

The Steering Angle Sensor (SAS) is used to measure the angle of the steering wheel and the speed at which it is being turned. The signal is mainly used by the ABS System as part of its stability control function but also by other systems such as ride level control and adaptive lighting. A problem with the SAS Signal will cause a fault with any of the systems that use the signal directly, or indirectly.
If the Steering Angle Sensor (SAS) needs to be changed, many vehicles require the new sensor to be calibrated. The ilink450 Tool will allow you to carry out steering angle re-calibration on supported models.

VIDENT iLink 450 DPF Regeneration or Replacement

Carry out a forced Diesel Particulate Filter (DPF) Regeneration is required when the DPF filter blockage reaches levels where passive or active regeneration is unable to burn off the excess soot. The iLink450 is also capable of regenerating Diesel Particulate Filters and resets the DPF light after the filter has been replaced.



VIDENT iLink 450 Vehicle Coverage:

Oil Light Service:
Acura, Abarth, Alfa Romeo, Audi, Aston Martin, BMW, Bentley, Bugatti, Citroen, Chrysler, Dacia, Ferrari, Fiat, Ford, GM, Holden, Honda, Hyundai, Infiniti, Isuzu, Jaguar, Kia, Lancia, Lexus, Land Rover, Mercedes Benz, Mini, Mazda, Maserati, Mitsubishi, Nissan, Opel, Peugeot, Porsche, Renault, Rolls-Royce, Saab, Seat, Skoda, Scion, Subaru, Suzuki, Smart, Sprinter, Toyota, Vauxhall, Volkswagen, Volvo

EPB Functions:
Acura, Abarth, Audi, Alfa Romeo, BMW, Bentley, Bugatti, Citroen, Daewoo, EU Ford, Ford, Fait, Ferrari, GM, Honda, Hyundai,
Jaguar, Kia, Land Rover, Lancia, Lexus, Maserati, Maybach, Mercedes Benz, Mini, Opel, Peugeot, Porsche, Roewe, Renault,
Rolls Royce, Saab, Scion, Seat, Skoda, Toyota, Vauxhall, Volkswagen, Volvo

Battery Configuration:
Audi, BMW, Citroen, Ford, Infiniti, Jaguar, Land Rover, Lexus, Mini, Mitsubishi, Nissan, Peugeot, Seat, Skoda, Toyota, Volvo, VW

ABS&SRS Diagnosis:
Chrysler, Ford, GM, Au Ford, Acura, Daewoo, Honda, Holden, Hyundai, Infiniti, Isuzu, Kia, Lexus, Mazda, Mitsubishi, Nissan, Scion, Subaru, Suzuki,
Toyota, Abarth, Alfa Romeo, Audi, Aston Martin,BMW, Bentley, Bugatti, Citroen, Dacia, EU Ford, Fiat, Ferrari,Jaguar, Lamborghini, Lancia, Land Rover,
Maybach, Mercedes Benz, Mini, Opel, Porsche, Peugeot, Renault, Rolls-Royce, Saab, Seat, Skoda, Smart, Sprinter, Vauxhall, Volkswagen, Volvo

DPF Functions:
Acura, Alfa Romeo, Audi, Bentley, Bugatti, Mercedes Benz, BMW, Chrysler, Citroen, Dacia, Fiat, GM, Honda, Hyundai, Infiniti,
Kia, Jaguar, Lancia, Lamborghini, Land Rover, Lexus, Maserati, Maybach, Mini, Mitsubishi, Nissan, Opel, Peugeot, Renault, Rolls-Royce,
SsangYong, Scion, Seat, Skoda, Sprinter, Subaru, Toyota, Vauxhall, Volkswagen, VW_CV

TBA/TPS(Throttle Body Alignment):
Acura, Audi, BMW, Citroen, Daewoo, Ford, Geely, GM, Honda, Hyundai, Infiniti, Kia, Land Rover, Lexus, Lincoln, Mitsubishi, Nissan, Opel, Peugeot,
Porsche, Saab, Seat, Skoda, Toyota, VW,BYD, Brilliance, Changan, Chery, Dpfv, Geely, Greatwall, Hnmazda, Huizhong, JAC, Lifan, MG, Qnlotus, Roewe, Spark, Wuling, Zzmazda, Zznissan




VIDENT iLink 450 Specification:

Display: 2.8” Backlit, 320X240 TFT color screen
Operating Temperature: 0 to 60°C (32 to 140°F)
Storage Temperature: -20 to 70°C (-4 to 158°F)
Power: 8 to 18 V provided via vehicle
Supported Protocols: J1859-41.6, J1850-10.4, ISO9141, KWP2000 (ISO 14230), and CAN (Control Area Network ISO 11898)
Tool Dimensions: 194*117*47mm (L*W*H)
Color Box: 220*165*85mm (L*W*H)
Weight: 0.9KG

Check: Vident iLink450 scan tool review

VIDENT iLink 450 Package includes:

1pc x Kit Include
1pc x Link450 Scan Tool
1pc x User Guide
1pc x Memory Card
1pc x USB Cable
1pc x Leather Carrying Pouch